Clippard Push-Quick Fittings provide a simple method of connecting pneumatic components and system piping. They are designed for use with both flexible hose and stiff tubing made of nylon, urethane, polyethylene or polypropylene.
Push-Quick Fittings generally provide higher flows than barbed fittings. The Push-Quick fitting allows full flow through the hose/tubing I.D. with no smaller orifice required as in barb fittings.
Medium: Air, inert gas, water, liquid, or oil
Pressure Range: 0 to 250 psig @ 75°F
Vacuum: 0 to 29.5” Hg
Tube Pull-Out Force: @ 75° 1/8” – 5/32”: >10 lb.;
(non-pressurized) 1/4” – 1/2”: >20 lb.
Temperature Range: 5 to 230°F
Materials: 316 stainless steel, FKM seals
Installation of Tubing or Hose into fitting
1. Slowly push a clean and perpendicularly cut tubing into the fitting until it comes to a dead stop.
2. Pull the tubing back gently until the Gripper Ring of the fitting grips onto the tubing and has a good seal.
Removal of Tubing of Hose from fitting
1. Push in evenly on the two long oval sides of the Release Button.
2. Pull out the tubing while keeping the Release Button depressed.
3. To reuse the tubing; cut off the lodged portion of the previously used tubing evenly and perpendicularly.
Installation of Pipe Fittings with Pre-Applied sealant
1. Tighten fitting by hand, then turn it 2 or 3 turns with a wrench until it reaches the desired torque listed.
2. If the fitting is used and the sealant coating is not in good condition, apply Teflon® sealant tape to the threads.
